Armasight NWWORION0411I11 ORION 4x GEN 1+ Night vision rifle scope - Manual (Page 7)

7
2) Remove the front lens cap.
3) Activate the unit by pushing the PWR button. After a momentary delay, a green light indicating cor-
rect IIT operation will appear.
4) Observe the scene and focus your Orion.
RETIClE
The Armasight Orion reticle provides a clear aiming point, even
when difficult-to-see games or objects blend into the background.
Posts and crosshairs appear in the center section of the field of view,
but occupy a minimal portion of the image, making precise shots on
even the smallest targets easy and accurate.
The size of the thin lines in the center of reticle corresponds as fol-
lows: 1.25 yards at 100 yard’s distance.
wInDAgE AnD ElEVATIOn ADjUSTMEnT
The vertical and horizontal adjustments of the Armasight Orion can
be regulated by adjusting the elevation and windage turrets. You
will first need to remove the dust caps. Each click indicates 1/4 of
an inch at 100 yard’s distance. Once the turrets stop turning, do not
attempt to turn them any further, as this may damage the mecha-
nism.
4. IR IllUMInATOR
Infrared illuminators are used in areas where the level of light is not sufficient for the unit to generate
a bright, clear image. An IR illuminator provides infrared light which, although invisible to the naked
eye, can greatly enhance the performance of night vision devices. Turn on the IR810 when working in
total darkness. Remember that the beam emitted by your IR illuminator will lose its brightness over
long distances.
IR IllUMInATOR InSTAllATIOn
The IR810 is a removable infrared illuminator that can be installed on the rail of the Orion. To install the
IR illuminator on your sight, perform the following steps:
1) Loosen the fixing screw on the IR810 mount.
2) Place the IR810 on the Picatinny rail.
3) Tighten the fixing screw.
IR IllUMInATOR OPERATIOn
The Armasight IR810 runs on a single CR123A battery. To install the battery, unscrew the battery com-
partment cap and insert the battery in accordance with the polarity markings on the unit’s body. Screw
the battery compartment cap back into position.
To turn the IR810 on, rotate the operation switch from the OFF position.
To adjust the power and brightness of the beam emitted by the IR810, rotate the illuminator operation
switch.
WindagE
ElEvation