Armasight NSBEAGLE032GDS1 EAGLE GEN 2+ SD Night Vision Binocular - Manual (Page 17)

17
1. Unscrew the battery cap (A) and insert the CR123A battery (B), observing polarity markings on the
body of the device.
2. With the battery adapter (C) installed, screw the battery cap (A) back on securely.
Install the AA battery as follows:
1. Unscrew the battery cap (A).
2. Unscrew the battery adapter (C) from the cap, turn it around, and screw in the other end.
3. Insert the AA battery (D), observing polarity markings on the body of the device.
4. Screw the battery cap (A) back into place.
3.1.2 MOUNTING A LONG-RANGE IR ILLUMINATOR TO THE EAGLE
To mount an IR illuminator to the Eagle, use the Dovetail to Weaver Transfer Piece. Perform the follow-
ing steps:
1. Install the transfer piece (A) onto one of the Eagle rails.
2. Tighten the two fixing screws (B) on the transfer piece.
3. Loosen the IR illuminator fixing screw (C).
4. Mount the IR illuminator on the Weaver rail of transfer piece and tighten the fixing screw (C).
B
C
FIGURE 3-2. MOUNTING AN IR ILLUMINATOR TO THE EAGLE
A
3.1.3 MOUNTING A CAMERA/ CAMCORDER TO THE EAGLE
To mount any 35mm SLR photographic camera or 8mm camcorder to the Eagle, use the optional cam-
era adapter and perform the following:
1. Using the (M37x0.75 threaded) adapter ring (B), screw the (M52x0.75 threaded) adapter (A) into the
front lens of the photographic camera or video camera.
2. Remove the eyecup from the Eagle eyepiece.
3. Connect the adapter with the eyepiece and tighten the three fixing screws (C) located on the adapt-
er.
B
C
FIGURE 3-3. MOUNTING A CAMERA/ CAMCORDER TO THE EAGLE
A