Babyliss G920E Homelight Face & Body - Manual (Page 147)

EN
149
8. Press the application surface firmly against your skin so that it is in full contact. When the application surface
is in full contact with the skin, the ‘Ready’ indicator light will begin to flash.
9. Press the release mechanism. The device will first check your skin colour.
If the skin colour is light enough for safe application, the appliance will release a pulse onto the skin and the
indicator light will turn off.
You will see a flash and at the same time you will hear a light ‘beep’ every time it pulses, which is normal.
You might feel a slight sensation of heat and prickling.
If you do not see a light pulse and the skin colour sensor indicator light begins to flash, this means
that your skin is too dark for safe use. Change the patch of skin being treated or check with the Help
Service for the Homelight epilator (see for more details: ‘Skin colour sensor’).
Your Homelight unit will begin recharging immediately after each pulse. After 4 seconds, the ‘Ready’ indicator
light will come on again.
10. Remove the application surface from the area of treated skin.
11. Move the application surface to another area to be treated. Pressure tracks from the application surface
made on your skin will help you to align the appliance correctly to administer another pulse, preventing
superimposing the pulses or spacing too much. (See ‘Covering the treatment area’).
12. Repeat the application from step 5.
Warning: Never treat the same patch of skin more than once per depilation session!
Repeated treatment of the same area increases the risk of side effects.