Xoro HTC 2233HD - Manual (Page 80)

12 HTC2233HD/2433HD
Engl
ish
1. Mount the stand.
2. Connect the aerial or input source to the appropriate input socket at the rear of the set.
3. Connect the small round plug on the power adaptor cable to the power input socket at the
rear of the set.
4. Connect the main cable between the power adapter and the main supply. The LED will show
a red light.
5. Switch the power on by pressing the POWER button on the front panel or the remote control.
The LED will show a green light.
6. Use the INPUT button on the front panel or the remote control and a popup window with the
sources appears on the screen. You can select following sources: ATV, VGA, YUV, AV,
HDMI1, HDMI2, SCART, DTV, USB or DVD. You can use the front panel control to adjust the
volume or select a channel, as shown below, or you may use the remote control and confirm
by OK button.
A. Analog TV tuner (for example: cable system)
After switched on and press the INPUT button and choose “ATV” by pressing the navigation
button UP/DOWN and confirm by the OK button. Now the HTC 2232D is in analogue TV
Mode. By the first using of the TV set, the systems starts automatically the menu for
searching the TV channels (please refer page 21).
B. DVD-Player:
Switch on the unit and press the INPUT button and choose “DVD” by pressing the
navigation button UP/DOWN and confirm by the OK button. Now the HTC 2232D is in DVD
Mode.
C. DVB-T mode:
Switch on the unit and press the INPUT button and choose “DTV” by pressing the
navigation button UP/DOWN and confirm by the OK button. Now the HTC 2232D is in DVB-
T mode. By the first using of the TV set, the systems starts automatically the menu for
searching the TV channels (please refer page 21).
7. To switch the set off a short time, press the POWER button, the set will go into stand-by and
the LED will show red. lf you are not going to use the set for some time, switch the power off
completely by unplugging the mains cable.
Quickstart Guide