Diodes AH180N - Manual (Page 3)

AH180N
Document number: DS32174 Rev. 4 - 2
3 of 8
www.diodes.com
August 2012
© Diodes Incorporated
AH180N
Absolute Maximum Ratings
(Note 4) (@T
A
= +25°C, unless otherwise specified.)
Symbol Parameter Ratings Unit
V
DD
Supply Voltage (Note 5) 7 V
B Magnetic Flux Density Unlimited
P
D
Package Power Dissipation
SC59 230
mW TSOT23 230
SOT553 230
Ts Storage Temperature Range -65 to +150 °C
T
J
Maximum Junction Temperature 150 °C
Notes: 4. Stresses greater than the 'Absolute Maximum Ratings' specified above, may cause permanent damage to the device. These are stress ratings
only; functional operation of the device at these or any other conditions exceeding those indicated in this specification is not implied. Device
reliability may be affected by exposure to absolute maximum rating conditions for extended periods of time
5. The absolute maximum V
DD
of 7V is a transient stress rating and is not meant as a functional operating condition. It is not recommended to
operate the device at the absolute maximum rated conditions for any period of time.
Recommended Operating Conditions
(@T
A
= +25°C, unless otherwise specified.)
Symbol Parameter Conditions Rating Unit
V
DD
Supply Voltage Operating 2.5 to 5.5 V
T
A
Operating Temperature Range Operating -40 to +85 °C
Electrical Characteristics
(@T
A
= +25°C, V
DD
= 3V, unless otherwise specified.)
Symbol Parameter Conditions Min Typ Max Unit
V
OUT
Output On Voltage I
OUT
= 1mA ⎯ 0.1 0.3 V
Ioff Output Leakage Current V
OUT
= 5.5V, Output Off ⎯ <0.1 1 µA
Idd(en)
Supply Current
Chip Enable, T
A
= +25°C, V
DD
= 3V ⎯ 3 6 mA
Idd(en)
Chip Enable, T
A
= -40 to +85°C,
V
DD
= 2.5V to 5.5V
⎯ 3 12 mA
Idd(dis) Chip Disable, T
A
= +25
°C, V
DD
= 3V
⎯ 5 10 µA
Idd(dis)
Chip Disable, T
A
= -40 to 85 °C,
V
DD
= 2.5V to 5.5V
⎯ 5 28 µA
Idd(avg)
Average Supply Current,
T
A
= +25
°C, V
DD
= 3V
⎯ 8 16 µA
Idd(avg)
Average Supply Current,
T
A
= -40 to +85 °C, V
DD
= 2.5V to 5.5V
⎯ 8 40 µA
Tawake Awake Time (Note 6) ⎯ 75 125 µs
Tperiod Period (Note 6) ⎯ 75 125 ms
D.C. Duty Cycle ⎯ 0.1 ⎯ %
Notes: 6. When power is initially turned on, V
DD
must be within its correct operating range (2.5V to 5.5V) to guaranteed the output sampling.
The output state is valid after the second operating cycle (typical 150ms).
Idd (dis)
Idd(en)
Tawake
Tperiod
0
Sample and output
latched