Braun C20S Independent Steam - Manual (Page 10)

• If the appliance is damaged, stop using it immediately.
For repairs refer to authorised Braun Service Agents
only.
Description
Ꭽ
Energy supply / start switch
(«0» = off, «1» = energy supply, «start» = starting)
Ꭾ
Temperature control
(only with models C 70 TS, C 100 TS)
Ꭿ
Ready indicator
൳
Water reservoir for steam function
൴
«open»-release button for handle
൵
Protective heat resistant cover with safety lock
൶
Round styling brush
൷
Halfround shaping brush
(only with models C 70 TS, C 100 TS)
൸
Leave-in rollers (only with model C 100 TS)
Inserting or changing the Braun energy cell
• The energy supply must be switched off (switch
Ꭽ
on position «0»). Press the «open»-release button
൴
and pull off the handle.
• Insert a Braun energy cell into the handle as shown in
the illustration. Push the handle with the energy cell
back onto the appliance until it snaps into place.
• The energy level in the cell can be checked through
the window at the bottom of the appliance.
Only use Braun energy cells. These are available from
the store where this appliance was purchased, as well
as from authorised Braun Service Agents. The energy
cells can be changed at any time, even if they are only
partly filled.
3589165_C20S_D/GB/F Seite 8 Dienstag, 13. November 2001 6:53 06