Acer Altos R700 - Manual (Page 101)

91
Problems with Network
The server hangs when the drivers are loaded:
• Change the PCI BIOS interrupt settings.
Diagnostics pass, but the connection fails:
• Make sure the network cable is securely attached.
• Make sure you specify the correct frame type in your NET.CFG file.
The Activity LED doesn’t light:
• Make sure the network hub has power.
The controller stopped working when an add-in adapter
was installed:
• Make sure the cable is connected to the port from the onboard
network controller.
• Make sure your PCI BIOS is current.
• Make sure the other adapter supports shared interrupts. Also,
make sure your operating system supports shared interrupts.
• Try reseating the add in adapter.
The add-in adapter stopped working without apparent
cause:
• Try reseating the adapter first; then try a different slot if necessary.
• The network driver files may be corrupt or deleted. Delete and
then reinstall the drivers.
• Run the diagnostics.
Cannot Connect to a Server
• Make sure you are using the drivers that are shipped on the
System Resource CD for the onboard network controller.
• Make sure the driver is loaded and the protocols are bound.
• Make sure the network cable is securely attached to the connector
at the system back panel. If the cable is attached but the problem
AR700SB-e.book Page 91 Monday, September 30, 2002 9:09 AM