11 q-start paths: status screens / set up(3) – Bell & Gossett 10 001 265R5 TechnoForce Pump Controller User Manual

Page 45

Advertising
background image

TECHNOFORCE Installation, Operation, and Maintenance

39

Installation

4.11 Q-Start

Paths: Status Screens / Set up(3)

Press the

QuickAccess/6 key at the Main Set Up menu display. Then press the ENTER key.

Q-Start will prompt the user for the parameters required to start up the system quickly. Some of these values will

already be correct due to the factory setup that is done for each TechnoForce Pump Controller. Use

PREV/( )

and

NEXT/( ) to navigate through these screens. The new settings will come in effect only if all the screens

have been navigated as shown in the flow chart above.
Note: Press Up (▲) and Down (▼) keys together to exit the Q-Start at any point of time. Exiting the Q-start

intermittently before the last screen has been navigated, changes made under Q-Start will not come in effect.

Advertising