Xylem II 231 P INSIDER - Manual (Page 3)

3
4/07
FRANKLIN™ CONTROL BOX
CONNECTIONS
1. Remove the cover from the front of the 3-wire Franklin™ control box.
2. Remove the yellow wire from the terminal strip at L2 and remove the blue wire completely from
the control box.
3. Connect the blue wire attached to the PumpSaver
®
to the L1 terminal on the solid-state switch.
4. Press the PumpSaver
®
onto the L1 and L2 terminals.
5. Connect the yellow wire to the bottom terminal on the PumpSaver
®
.
Figure 1: Franklin™ Control Box without the Model 231-P-INSIDER