Xylem IMS SDQ 1 S-Drive Quick Start Up Guide - Manual (Page 2)

S-Drive Typical Installation
3
FLOW
4
6
5
1
2
8
9
7
L1
L2
L3
GND
T1
T2
T3
GND
10
11
SUPPLY POWER
1 S-Drive Controller
2 Fusible Disconnect
3 Pressure Gauge
4 Air Diaphragm Tank
5 Pressure Transducer
6 3 Phase Output (Always)
7 Discharge Check Valve
8 Gate Valve (Highly Recommended)
9 Submersible Pump End
10 Submersible Motor (3 Phase)
11 Pressure Relief Valve
NOTE: for single phase input, connect L1 and L3, then set motor overload switches to
50% of controller rating or lower.
Xylem Inc.
www.xyleminc.com
© 2011 Xylem Inc. IMS-SDQ-1 December 2011