YSI IQ SensorNet MIQ/PS Module User Manual
Page 14
Installation
MIQ/PS
3 - 6
ba76029e01
01/2012
Warning
No free wires are allowed to project into the housing. Otherwise,
there is a danger that safe areas could come into contact with dan-
gerous voltages. This could lead to danger when working with the
IQ S
ENSOR
N
ET
. Always cut off any wires that are not in use as
closely as possible to the cable gland.
6
Screw the cable gland (pos. 1 in Fig. 3-2) with the sealing ring
(pos. 2) into the module housing.
7
Loosen the coupling ring (pos. 3).
8
Feed the power line through the cable gland into the module
housing.
9
Connect phases L and N to the terminal strip. Make sure that
the cable assignment agrees with the specification on the ter-
minal label under the terminal strip.
10
Tighten the coupling ring (pos. 3).
11
Close the module.