Xylem EZ100 Sensor Display - Manual (Page 4)

Global Water
800-876-1172 • globalw.com
- 4 -
III. Display Installation
a. The Display is designed for handheld applications, however there are
four holes in the back of the case that may be used to mount the unit
to a flat surface (screws not included.)
b. If the Display is mounted insure that it is located in an area that is
protected from direct rainfall and immersion in water. The Display is
water resistant, not water proof.
c. See Appendix B for installation of Display with external power source
and/or additional external recording/monitoring device.
IV. Display Set Up and Use
Output Range: +1900 Engineering Units
Input Range: 4-20 mA
Accuracy: +0.1% of full scale
Operating Voltage: 12-36VDC
Current Draw: Same as sensor output
Warm Up Time: 3 seconds
Operating Temperature: 0° to +60°C
Size of Probe:
4 ¾”x3 1/8”x2 1/8”
Weight: 0.5 lb.
a. If the EZ100 was shipped with a sensor attached, the display was
calibrated for that sensor at Global Water’s factory. Pressing the
button on the front of the EZ100 will display the sensor’s output.
Please read the sensor manual for installation and maintenance
instructions.