Xylem 704 PUMP CONTROLLER - Manual (Page 13)

13
Pumping Station name: Pumping Station no.: Date:
Serial no.: Sensor no.:
ACCESS CODE MEASURING SYSTEM CONTROLLER FOR
yes no ultrasonic hydrostatic pump out pump in
code level level and altitude
ALTERNATING
sensor and span
select unit m bar kPa cm mm normal in pairs
select comma 1 . 234 12 . 34 123 . 4 1234
select span
altitude
sensor altitude
max. level
sensor level (704U)
RELAY PROGRAMMING
in use relay for at control at alternating
control
at alarm at level alarm relay delay
yes no control alarm alter-
nating
direct level in
use
level not
in use
system
failure
level
alarm
set
>
reset
set
<
reset
relay 1 sec.
relay 2 sec.
relay 3 sec.
relay 4 sec.
mA OUTPUT
mA span mA orientation
4 - 20 mA 0 - 20 mA 0/4 - 20 mA 20 - 0/4 mA 0 / 4 mA =
20 mA =
PUMPFLOW CALCULATION
yes no
level for volume start
level for volume stop
the volumes capacity
correction factor
START / STOP LEVELS
start stop
relay 1
relay 2
relay 3
relay 4