Xylem RainPerfect Solar Powered Rain Barrel Pump System - Manual (Page 3)

PuMP asseMBly
Battery installatiOn &
PuMP OPeratiOn
Hole dimensions
Hose HeigHt Adjustment &
Hose ClAmp Assembly
to operAte tHe pump
CAble AttACHment
bAttery instAllAtion
if your rain barrel does not have a hole cut out of the
top, simply drill a minimum 2.25 inch hole and drop the
pump into the barrel.
When inserted, the pump should remain approximately 2
inches above the bottom of the barrel.
Hold down the yellow button for three seconds to turn the
pump on and off. a green light will display while the pump
is running.
line up male and female connectors from the control box
to the solar panel or pump, press firmly together and finger
tighten sealing sleeve.
Note: Battery is shipped disconnected and must be
installed prior to use.
Please see the battery connection instructions on the
bottom of the control box for proper battery installation.
Ensure the pump is powered off. Tap the yellow button
once to determine how much charge is left in your battery.
to test tHe bAttery
Green = Good (100% - 85%)
Yellow = OK (85% - 80%)
Red = Charge (80 - 75%)
If battery voltage is below
75%, the pump will not
turn on.
3 4