Xylem ProLab 1000 - Manual (Page 11)

ProLab 1000 Overview
11 ba75576e05 11/2013
1.5 Automatic sensor recognition
The automatic sensor recognition function enables
 to operate a sensor with different meters without recalibrating
 to operate different sensors with one meter without recalibrating
 to assign measurement data to a sensor
– measurement datasets are always downloaded to the interface
with the sensor type and sensor series number.
– measurement datasets are always stored together with the
sensor type and sensor series number.
 to assign calibration data to a sensor
– calibration data is always downloaded to the interface with the
sensor type and sensor series number.
To be able to use the automatic sensor recognition function a meter is
required that supports the automatic sensor recognition (e.g.
ProLab 1000), and a sensor (ID sensor) that is suitable for sensor
recognition.
In every ID sensor, sensor data is stored that clearly identifies the
sensor.
The sensor data is sent to the meter automatically via radio
communication and used for sensor identification there.
Note
With the ProLab 1000 meter, you can also operate non-ID sensors.
Then, however, you cannot use the advantages of the sensor
recognition function.
DIN
BNC