Xylem WA400 HIGH WATER ALARM - Manual (Page 7)

Global Water
800-876-1172
• globalw.com
- 7 -
b. Connect the switch closure sensor to the LEVEL SWITCH terminals.
Sensor cabling should be cut to appropriate length to allow wiring and
alarm board to fit into the enclosure. Make sure power is off when
connecting sensor.
Note: Refer to manual of the attached device for correct wiring.
c. Turn the switch to the ON position to put the alarm into the active
state. Alarm will only sound when sensor is triggered by alarm contact.
Test button can be used to test strobe and speaker functionality. Hold
test button down for 2 seconds to activate speaker and strobe.
Release button to turn off speaker and strobe once functionality is
verified.