Extron Electronics DMP 44 LC User Guide - Manual (Page 11)

Installation
This section describes the installation of the DMP 44 LC, including:
• Mounting the DMP 44 LC
• Rear Panel Features and Cabling
Mounting the DMP 44 LC
The 1U high, quarter rack width, 3.0 inch deep DMP 44 LC Digital Matrix Processor can
be:
• Set on a table,
• Mounted on a rack shelf,
• Mounted under a desk or tabletop, or
• Mounted on a projector bracket.
See “ Mounting ” in the “ Reference Information ” section for detailed mounting
instructions.
Rear Panel Features and Cabling
DMP 44 LC
RESET
Tx Rx 1 2 3
RS-232 DIGI IN 3 4
1 2
3 4
1
INPUTS
2
OUTPUTS
POWER
12V
0.3A MAX
7
1 2 3 4 5 6
Figure 1. DMP 44 LC Rear Panel
a
Power connector — Connect the included 12 VDC external power supply into the
2-pole 3.5 mm captive screw connector. Be careful to observe the correct polarity.
DMP 44 LC • Installation 5