Xoro HTL 2231D - Manual (Page 100)

48 HTL 2231D
Engl
ish
LCD Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Technical Support of Xoro/MAS:
•
Tel.: +49 40 77 11 09 17
• Internet: www.xoro.de/support.htm
Problem Solution
TV won’t switch on • Check the mains cable is connected properly to both the mains supply
and the mains adapter
• Check the cable from the mains adapter is connected properly to the
set.
• The electronic circuit may have reset. Pull the plug out, wait for 60
seconds, then plug back again.
No picture • Check the aerial or other input is connected properly.
• Check that the correct input is selected, using the SOURCE button.
• Check the brightness and contrast settings in the Picture Setting.
No sound • Check that the VOLUME isn’t turned down, or the MUTE button
pressed.
• Check that the audio cables are connected to the correct inputs.
Picture has wrong
colour • Check that the correct input is selected, using the SOURCE button.
The picture is
unstable when used
with a PC • Check the Picture Setting and adjust the view by Auto Adjust match the
video output settings of the PC.
There are a few
coloured spots on the
screen • High resolution LCD screens often have a small number of faulty
pixels.
• This is normal and within the bounds of our quality control checks.
Picture with wrong
scaling • The LCD has the wrong aspect ratio. Please press the ASPECT button
to switch the aspect ratio from 16:9 to 4:3.
No DVB-T reception • Switch the player into the DVB-T mode.
• No DVB-T reception in your region.
• Realign the antenna. Please pay attention to the direction of the
antenna tower.
• Please use an active indoor aerial or a roof antenna.
• Retry the Auto Scan.
Picture freezes • Realign the antenna. Please pay attention to the direction of the
antenna tower.
• Please use an active indoor aerial or a roof antenna.
Strong mosaics or
artefacts • Realign the antenna. Please pay attention to the direction of the
antenna tower.
No searching possible • Realign the antenna. Please pay attention to the direction of the
antenna tower.
• Control the Country selection
No Audio or no
second audio
language Press the NICAM button. Many TV broadcaster supports just only one
language.
No subtitles Press the SUB-T button. Many TV boradcaster does not support
subtitles.