Xoro HTL 2231D - Manual (Page 63)

HTL 2231D 11
Engl
ish
1. Mount the stand in order to the description on the previous page.
2. Connect the aerial or input source to the appropriate input socket at the rear of the set.
3. Connect the small round plug on the power adaptor cable to the power input socket at the rear of
the set.
4. Connect the main cable between the power adapter and the main supply. The LED will show a
red light.
5. Switch the power on by pressing the POWER button on the front panel or the remote control. The
LED will show a green light.
6. Use the SOURCE button on the front panel or the remote control and a popup window with the
sources appears on the screen. You can select following sources: DTV, ATV, SCART, AV,
Component, VGA, HDMI or USB. You can use the front panel control to adjust the volume or
select a channel, as shown below, or you may use the remote control and confirm by OK button.
A. Analog TV tuner (for example: cable system)
After switched on and press the SOURCE button
and choose “ATV” by pressing the navigation
button UP/DOWN and confirm by the OK button.
Now the HTL 2231D is in TV Mode. By the first
using of the TV set, the systems starts
automatically the menu for searching the TV
channels (please refer page 20).
B. Multimedia-Player:
Switch on the unit and press the SOURCE button
and choose “Storage” by pressing the navigation
button UP/DOWN and confirm by the OK button.
Now the HTL 2231D is in USB Mode.
C. DVB-T mode:
Switch on the unit and press the SOURCE button
and choose “DTV” by pressing the navigation
button UP/DOWN and confirm by the OK button.
Now the HTL 2231D is in DVB-T mode. By the
first using of the TV set, the systems starts
automatically the menu for searching the TV
channels (please refer page 20).
7. To switch the set off a short time, press the POWER button, the set will go into stand-by and the
LED will show red . lf you are not going to use the set for some time, switch the power off
completely by unplugging the mains cable.
Quickstart Guide