Extron Electronics Dante Controller - Manual (Page 28)

Dante Controller User Guide
Copyright © 2013 Audinate Pty Ltd. All rights reserved. -28-
n
Device Name: The label currently associated with the device
n
Product Type: The product type
n
Product Version: The product version
n
Primary Address: The IP address assigned to the primary interface. IP addresses are currently
assigned via DHCP or automatically self-assigned. Self assigned addresses on the primary
interface will be in the 169.254.X.Y range.
n
Primary Link Speed: The Ethernet link speed that the primary interface is currently operating over
(i.e. 1Gbps or 100Mbps).
n
Secondary Address: The IP address assigned to the secondary interface. IP addresses are
currently assigned via DHCP or automatically self-assigned. Self assigned addresses on the
secondary interface will be in the 172.31.X.Y range.
IP Address Assigned P address
Link Down Secondary Dante interface supported but not connected
Not supported Secondary Dante interface not supported
n
Secondary Link Speed: Indicates the Ethernet link speed that the secondary interface is currently
operating over (i.e. 1Gbps or 100Mbps). Other values as described above for Secondary Address.
Note: A Dante interface may have a preferred link speed. Where it does and the primary and/or
secondary interface is not operating at that preferred link speed, the values in the Primary Link Speed
and/or Secondary Link Speed columns will be presented in red.
Note: Older Dante devices may not support querying of some of this information. In this case the
relevant column will display “Not Supported”.
Clock Status View
The Clock Status tab within the Network View provides a network wide overview of the clocking state
within the network.