Command and response table for, Dvs 510 series sis commands, Input selection – Extron Electronics DVS 510 Series User Guide User Manual
Page 61
DVS 510 Series • Remote Configuration and Control
55
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Input Selection
Video and audio
X!
!
In
X!
•
All
]
Select video and audio from input source
X!
.
Video
X!
&
In
X!
•
RGB
]
Select video from input source
X!
.
Audio
X!
$
In
X!
•
Aud
]
Select audio from input source
X!.
NOTES:
•
When the DVS is in PIP mode, the input selection command affects the PIP window. In addition, all picture
controls and advanced input settings apply to the PIP input.
•
Query commands (!, &, and $) return the full tagged response as seen in verbose modes 2 and 3. However,
responses that include only the
X!
variable are returned in verbose mode 0 or 1 (not tagged).
Input Video Format
Set video format
X!
*
X#
\
Typ
X!
*
X#
]
Set input
X!
to video format
X#
.
View video format
X!
\
X#
]
View video type of input
X!
.
Input EDID (Inputs 5, 6, 8, and 10 only — DVI and VGA)
Specify an EDID value
E
A
X!
*
X2!
EDID
}
Edid
A
X!
*
X2!
]
Set the EDID resolution and refresh rate
for input
X!
to
X2!
.
View EDID data
E
A
X!
EDID
}
X2!
]
In verbose mode:
Edid
A
X!
*
X2!
]
View the EDID setting for input
X!
.
Auto-Image
Enable Auto-Image
X!
*
1
A
Img
X!
*
1
]
Perform Auto-Image on input
X!
when
it is selected or when a new signal is
applied.
Disable Auto-Image
X!
*
0
A
Img
X!
*
0
]
Turn off Auto-Image for input
X!
.
View Auto-Image
X!
A
X!
]
View the current Auto-Image setting for
input
X!
.
Execute an Auto-Image
A
Img
]
Perform an Auto-Image for the current
input.
Execute and fill
1
*
A
Img
1
]
Perform an Auto-Image on the current
input and fill the entire output display.
Execute and follow
2
*
A
Img
2
]
Perform an Auto-Image on the current
output and follow the aspect ratio of the
input.
NOTE:
X!
= Input selection
1 through 10
X#
= Input video format
1 = RGB, 2 = YUVp/HDTV, 3 = RGBcvS, 4 = YUVi, 5 = S-video,
6 = Composite video, 7 = DVI
X2!
= EDID resolution and refresh rate
on page 53 for the available values.
Command and Response Table for DVS 510 Series SIS Commands