Installation and operation, Rear panel features – Extron Electronics FOX DA8 User Guide User Manual

Page 10

Advertising
background image

Installation and

Operation

The topics covered in this section are:

z

Rear Panel Features

z

Front Panel Features

z

System Operation

Rear Panel Features

FOX DA8

OPTICAL OUTPUTS

INPUT

OUT IN

1

OUT N/A

2

OUT N/A

3

OUT N/A

4

OUT N/A

5

OUT N/A

6

OUT N/A

7

OUT N/A

8

100-240V 0.3A

50/60 Hz

RS-232

Tx Rx

4

1

2 3

3

3

3

3

3

3

3

Figure 2.

FOX DA8 Connectors

WARNING: This unit outputs continuous invisible light, which may be harmful and

dangerous to the eyes; use with caution. For additional safety, plug the
attached dust caps into the optical transceivers when the fiber optic cable
is unplugged.

NOTES:

•

Singlemode and multimode devices are not interchangeable. Ensure that you

connect transmitting and receiving devices that are compatible with the
FOX DA8.

•

Ensure that you use the proper fiber cable for your system. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange
jacket.

•

In this guide, the term “sending connector” refers to an LC connector on a
device that outputs a fiber optic signal. The term “receiving connector” refers
to an LC connector that receives an optical signal.

a

AC power connector — Plug a standard IEC power cord into this connector to connect

the FOX DA8 to a 100 VAC to 240 VAC, 50 or 60 Hz power source.

Extron FOX DA8 • Installation and Operation

4

Advertising