Extron Electronics MLM-UDSM - Manual (Page 5)

 MLM-UDSM • Installation Guide
7. Replace or add labels, if needed. Refer to the MediaLink Controllers User’s
Manual for instructions.
8. Turn the MLM-UDSM sliding enclosure’s top plate right side up.
9. Align the openings in the sliding enclosure’s top plate with the controller’s
buttons, knob, and LEDs, and place the top plate on the MLC as shown below.
10. As shown below, insert the four screws removed in step 5, and tighten them to
secure the MLC to the MLM-UDSM sliding enclosure’s top plate.
Ext
ron
ML M-U DS M
DIS PL AY
PO WE R
VO LU ME
MA X/
MIN
4 Screws
MLC 206
11. Attach cables to the MLC’s bottom panel connectors. See the MediaLink
Controllers User’s Manual for details.
12. Set up the MLC. Refer to the MediaLink Controllers User’s Manual for details.
13. Install the rail guides onto the sides of the sliding enclosure’s bottom panel as
shown below, and press them into place.
Install rail guide
(each side)