Extron Electronics Matrix 12800 Series User Guide - Manual (Page 20)

2-5 Matrix 12800 Switchers • Installation
PRELIMINAR
Y
k
Balanced and unbalanced audio input connectors — See page 2-13 .
l
Audio outputs connectors — See page 2-14 .
m
FPC Comm port — (FUTURE CAPABILITY)
n
MCP/MKP Comm ports — See page 2-14 .
o
Ethernet port — See page 2-15 .
p
External Sync connectors — See page 2-16 .
Pre-virtualization operations
BME settings
a
BME address switch — Each BME must be set to a unique address of 0
through 8. Address 9 is invalid. The addresses used in the system must be
sequential with no skipped numbers, other than as required for audio BMEs.
Audio BMEs occupy two BME addresses: the set address and the set address
plus 1 (for example, if the audio BME is set to address 3, it occupies addresses
3 and 4). Set the next BME after the audio BME to the address number plus 2
of the audio BME (for example, if the audio BME is set to address 3, set the
next BME to address 5).
Sync BMEs cannot be set to address 0.
To set the BME address, press the + and - buttons on the BME Address switch
on the rear panel of the switcher (figure 2-2).
DISCONNECT BO
TH PO
WER CORDS BEFORE SE
RV ICING.
100-240V 5.0A MAX 50/60Hz FUSE 250V 5.0A
T
POWER SUPPLIES
CPU STATUS BME
PRIMARY
REDUNDANT
PRIMARY
REDUNDANT
SYNC
+V -V
ADDRESS
4
-
+
100-240V 5.0A MAX 50/60Hz FUSE 250V 5.0A
T
PRIMARY AC
POWER INPUT
REDUNDANT AC
POWER INPUT
IN
OUT
1
BME
ADDRES
S
ANAHEIM,
CA
MADE IN US
A
4
For prote
ction
against r
isk of
fire , replac
e only wi
th sam
e
type an
d rating
of fus
e.
CA UTIO
N
ADDRESS
4
BME
REDUN
DANT
AC
PO WER INPUT
100-240V 0.5A MAX 50/60Hz
PRIMAR
Y AC PO WER INPUT
100-240V 0.5A MAX 50/60Hz
PRIMAR
Y REDUND
ANT
PO WER SUPPLIES +v -v
CPU S
TATUS
PRIMAR
Y REDUND
ANT
SYN C
OU T
IN
Figure 2-2 — Setting a BME address