Speaker connections, Remote – Extron Electronics MPA 401 Series User Guide User Manual

Page 15

Advertising
background image

Speaker Connections

f

Speaker receptacle (see figure 2) — Connect
the speakers to the speaker receptacle using the
2-pole, 5 mm screw-lock captive screw connector
(MPA 401-100V shown at right).

NOTES:
• The mono audio speaker receptacle may be labeled in one of two ways (see

the diagrams above). The wiring and function are the same whichever way the
product is labeled.

• The MPA 401 amplifier sums the left and right signals from both the TRS and

RCA inputs to form Sum 1. Sum 1 is then weighted. At the same time, the
amplifier sums the left and right signals from the captive screw input to form
Sum 2. Sum 1 and Sum 2 are then summed together to form a single mono
signal. See figure 6 below for more details.

• The captive screw, RCA and TRS inputs are buffered.

Amp Stage

+

+

RCA

R

L

R

L

Captive

Screw

+

+

R

L

+-
+-

+

+

Sum 1

Sum 2

3.5 mm

TRS

Figure 6.

Summing MPA 410 input signals to form a single mono output signal

The MPA 401-70V provides up to 40 W for a 70 V line distributed sound system; the
MPA 401-100V provides up to 40 W for a 100 V line distributed sound system.
See the

attention

and the

note

on page 6 for important information about

connecting wires to captive screw connectors.

ATTENTION: Do not ground or short the speaker outputs as this will damage

the amplifier.

CLASS 2 WIRING

100V OUTPUT

OUTPUT

100V

MPA 401-70V and MPA 401-100V • Rear Panel and Cabling

9

Advertising