Extron Electronics MS9400 HD FrEND - Manual (Page 14)

MS9400 HD FrEND User Guide Chapter 2: Player Controls and Set-Up
14 Rev. 1.54
“Quick Start”
Assuming correct connection of the MS9400 into a display system, perform system steps 1-3 below to turn on the
player:
1. Turn ‘on’ the main POWER OFF/ON switch at the rear of the player (the power LED on the front panel
will glow). NOTE: Should the power Led not illuminate, verify that the power supply is securely
connected then toggle the power switch between OFF/ON.
2. The Hard Drive Led will flash during initialization (this could take up to 1 minute).
3. Once initialization is finished, a pre-loaded file will begin playing. Video will appear on the display and
audio will be heard from the speakers - this confirms the correct system ‘hook-up’. Default play mode is
‘Loop Play’; the file will continue playing repeatedly until the MS9400 receives a ‘Stop’ command from
the remote control.
To play a different Test File:
The user may wish to view other Test File(s) present on the MS9400:
1. Press the <MENU> button on the remote control (having first, pressed the <PC> or <MS9400> button).
The on-screen menu appears with a list of the Test Files pre-loaded in the Clips folder on the MS9400:
2. Use the joystick to navigate to the desired file. Press <SELECT> on your hand-held remote control (the
file will be highlighted).
3. Navigate to and Click <Play> on the menu; the chosen file will begin loop-play until it receives a stop
command.
4. Press the <STOP> button on your hand-held remote control. The player display will go black.
5. Press <MENU> to return to the main menu
Refer to Chapter 4: Playing Files for more information