Extron Electronics MLM-WB+ - Manual (Page 14)

MLM-WB+ • Installation 8
Required Tools
To install the MLM-WB+ you need the following tools:
• Phillips screwdriver • Pencil
• Flat head screwdriver • 3/8-inch wrench or ratchet
• Drill with drill bits • Wire cutter
• Level
Adjusting the Door Angle
Before mounting the MLM-WB+, ensure that the door opens to a 90º angle. To adjust the
door angle:
1. Set the MLM-WB+ upright on a flat surface and open the door.
CAUTION: Risk of Bodily Injury: If not properly secured in place, the
MLM-WB+ can potentially fall forward.
2. Remove the screws holding the clevis brackets to the door.
3. Slide the clevis brackets:
• Forward, to make the door open to a higher position, or
• Backward, to make the door open to a lower position.
Figure 7. Sliding the Clevis Brackets to Adjust the Door Angle
4. Align the holes on the clevis bracket with the holes on the door.
5. Replace the screws that were removed in step 2.