Installation, Installation overview – Extron Electronics MLM-WB+ User Manual

Page 9

Advertising
background image

MLM-WB+ • Installation

3

Installation

This section contains instructions for installing the MLM-WB+ and for connecting cables
to equipment in the wall box. The following topics are discussed:

•

Installation Overview

•

Accessibility Requirements

•

Components, Hardware, and Required Tools

•

Adjusting the Door Angle

•

Mounting the MLM-WB+

•

Routing Cables into the MLM-WB+

•

Installing Equipment

•

Testing the Installation

•

Completing the Installation

•

Adjusting the Door Lock

•

Ordering Additional or Replacement Keys

Installation Overview

WARNINGS: Risk of Severe Bodily Injury:

•

Do not sit on or lean against the door or the 4U rack enclosure.

•

For safety considerations, Extron recommends that no more than 15 pounds (7
kg) be placed on top of the open door.

ATTENTION: Potential Damage to Property: All installation and service

procedures should be performed by a qualified Extron installer or an electrician.
Extron is not responsible for equipment failure or damage occurring as a result of
an improper installation.

NOTE: Contact a contractor or hardware specialist for assistance with the

installation. Your installation may require additional hardware beyond what Extron
provides with the MLM-WB+.

Identify components and mounting hardware for the MLM-WB+ and obtain the tools
required for installation (see

Components, Hardware, and Required Tools

on

page 7).

1.

Select the installation site. On nonmasonry walls, the MLM-WB+ must be attached
to at least one stud. The recommended installation suggests that the wall box be
attached to two wall studs or to a concrete or masonry wall.

2.

Mount the outer enclosure onto the wall, and route power cables of the electrical
devices into the junction box inside the MLM-WB+.

3.

Wire power cables to the duplex receptacles, and secure the receptacles and
junction box cover to the junction box.

Advertising