Terminate the speaker cable for the pvs switcher – Extron Electronics PoleVault Systems PVS 305SA User Manual

Page 29

Advertising
background image

2-18

PoleVault Systems Installation • Installation — Stage 3

4c

Wire the captive screw connector.

PVS Switcher

Rear Panel

Speaker 1

Speaker 2

L

R

4/8

Ohms

AMPLIFIED OUTPUTS

4-pole Captive

Screw Connector

Audio output

to speakers

8 Ohm Load

Stereo R–

Stereo R+

Stereo L–

L

R

8 Ohms

AMPLIFIED OUTPUTS

Stereo L+

Stereo or dual mono output using parallel speaker wiring

Stereo output

Dual mono output

8 Ohm Load

L

R

8 Ohms

AMPLIFIED OUTPUTS

Mono –

Mono +

Mono –

Mono +

4 Ohm Total Load

4 Ohm Total Load

Two 8 ohm speakers
wired in parallel
equal a 4 ohm load.

L

R

4/8 Ohms

AMPLIFIED OUTPUTS

Mono –

or

Stereo R-

8
ohms

8
ohms

Mono +

or

Stereo R+

Mono –

or

Stereo L-

Mono +

or

Stereo L+

8
ohms

8
ohms

Speaker

Wire color

To PVS 305SA terminal

(Left and Right)

Red

Positive (+)

Black

Negative (-)

3. Terminate the speaker cable for the PVS

switcher

a.

To terminate the cable, strip the end of the cable 0.2 inch

(5 mm) and secure the wires into the supplied

4-pole captive screw connector.

N

The correct speaker impedance loading must be

observed when setting up a speaker system.

See figures below for examples.

N

By default, the amplifier is set for dual mono output. Use the software or SIS

™

(Extron Special Instruction Set)

commands to change the setting to stereo if desired. For full details, refer to the

PVS 305SA Users Manual,

available online at

www.extron.com

Advertising