Extron Electronics RGB 202xi User Guide Rev. E - Manual (Page 19)

Extron • RGB 202xi Series • User’s Manual
3
Chapter Three
Operation • Controls and Indicators
Auto Power
Level and Boost
Peaking
Blue Enhance
Vertical and Horizontal Centering
Scan-rate Indicator
Input Switch
Rear Panel DIP Switches
RGB 202xi, RGB 202 VTG,
RGB 202 VS2 and RGB 202 VS SL2
User’s Manual
Extron • RGB 202xi Series • User’s Manual Page 4-3
RGB 202 Model Differences
RGB 202 VS SL2 (VideoShift™ and ShiftLock™)
The VS SL2 model includes both VideoShift™ and
ShiftLock™ features. The VideoShift™ controls are on
the front panel and the ShiftLock™ controls are on the
back panel.
The VideoShift is the same as that described for the VS2
model.
The ShiftLock™
feature allows two
or more RGB 202
VS SL2 units to be
linked together,
such that one of the units controls the VideoShift for all. A
toggle switch on the back panel allows one to be set as
the “Master”. Each of any other units connected must be
set as “Slave”.
_ When the switch is set to “Slave”, the
VideoShift controls for that unit are
disabled.
Two connectors on the back panel
(see right) are used to connect the
Master and Slave(s).
Setup example:
1. The Master unit will have a cable connected from its
“ShiftLock Out” to the
“ShiftLock In” port of the
first Slave. Its toggle
switch must be set to the
“Master” position.
2. The first Slave will have a
cable from its “ShiftLock
Out” to the “ShiftLock In”
of the next Slave. Its
toggle switch must be set
to the “Slave” position.
3. Step #2 will repeat for
each Slave unit, except
that the last Slave (or the
only Slave), will have no
cable in its “ShiftLock Out” connector.
MASTER IN OUT
SLAVE
1
2
MASTER IN OUT
SLAVE
1
2
MASTER IN OUT
SLAVE
1
2
MASTER IN OUT
SLAVE
1
2