Configuration and control, Installing and starting the smx control program, Installing the program – Extron Electronics SMX System Setup Guide User Manual

Page 38: Installing and starting the smx, Control program, Perform this reset (see

Advertising
background image

SMX System MultiMatrix Switcher • Control and Configuration

32

Configuration and

Control

This section describes alternative methods of control for the SMX
through the SMX Control Program or accessing HTML pages and
includes:

•

Installing and Starting the SMX Control Program

•

Accessing the HTML Pages

•

Using the Web Pages to Configure the SMX

Installing and Starting the SMX Control Program

The SMX can be configured and operated via the Windows-based
SMX Control Program. This program is contained on the Extron
Software Products DVD (included with the SMX). Install and run this
program on a PC running Windows and connected to either of the
SMX serial ports or the Ethernet port. See

b

and

d

, on

page 3

for

connection information. It cannot be run from the DVD drive.

NOTE: For full details on operating the program, refer to the

SMX User Guide.

Installing the Program

1.

Insert the DVD into the drive. The DVD self starts.

TIP: If the DVD does not self start, run Launch.exe from the

DVD.

The Extron Software DVD window appears.

Figure 23.

Extron Software DVD Window

Advertising