Reference material, Ethernet link, Choosing a network cable – Extron Electronics SMX System Setup Guide User Manual

Page 43: Terminating the network cable, Choosing a network cable terminating the network, Cable, Mounting the smx, Installing new boards, Crossover, Figure 29. rj-45 connector pinout tables

Advertising
background image

SMX System MultiMatrix Switcher • Reference Material

37

Reference Material

This section describes Ethernet links, connector wiring, mounting
methods, and board installation. Topics in this section includes:

•

Ethernet Link

•

Mounting the SMX

•

Installing New Boards

Ethernet Link

The rear panel Ethernet connector on the SMX can be connected to an
Ethernet LAN or WAN. This connection allows for SIS control using a
computer connected to the same LAN. Ethernet cables must be of the
correct type, properly terminated relevant to the application, and with
the correct pinout.

Choosing a Network Cable

Use Category (CAT) 3, 4, 5, 5e, or 6 unshielded twisted pair (UTP) or
shielded twisted pair (STP) cables, terminated with RJ-45 connectors.
Ethernet cables are limited to 328 feet (100 m). Half-duplex and
full-duplex Ethernet connections are allowed. The cable used depends
on the network speed:

•

10 Mbps (10Base-T Ethernet) requires, at a minimum, CAT 3 UTP or
STP cable.

•

100 Mbps (100Base-T fast Ethernet) requires, at a minimum, CAT 5
UTP or STP cable.

Terminating the Network Cable

Terminate as either a patch or a crossover cable (see

figure 29

).

•

Crossover cable — Connection between the computer and the SMX.

•

Patch (Straight) Cable — Connection of the SMX to an Ethernet LAN.

Straight-through Cable

(for connection to a switch, hub, or router)

End 1

End 2

Pin Wire Color

Pin

Wire Color

1

white-orange

1

white-orange

2

orange

2

orange

3

white-green

3

white-green

4

blue

4

blue

5

white-blue

5

white-blue

6

green

6

green

7

white-brown

7

white-brown

8

brown

8

brown

Crossover

(for direct connection to a PC)

End 1

End 2

Pin Wire Color

Pin

Wire Color

1

white-orange

1

white-green

2

orange

2

green

3

white-green

3

white-orange

4

blue

4

blue

5

white-blue

5

white-blue

6

green

6

orange

7

white-brown

7

white-brown

8

brown

8

brown

Figure 29.

RJ-45 Connector Pinout Tables

12345678

RJ-45 Connector

Insert

Twisted

Pair Wires

Pins:

Side View

Straight-through Cable

(for connection to a switch, hub, or router)

End 1

End 2

Pin Wire Color

Pin

Wire Color

1

white-orange

1

white-orange

2

orange

2

orange

3

white-green

3

white-green

4

blue

4

blue

5

white-blue

5

white-blue

6

green

6

green

7

white-brown

7

white-brown

8

brown

8

brown

Crossover Cable

(for direct connection to a PC)

End 1

End 2

Pin Wire Color

Pin Wire Color

1

white-orange

1

white-green

2

orange

2

green

3

white-green

3

white-orange

4

blue

4

blue

5

white-blue

5

white-blue

6

green

6

orange

7

white-brown

7

white-brown

8

brown

8

brown

Advertising