Installation and operation, Installation overview – Extron Electronics RGB 580xi User Guide User Manual

Page 7

Advertising
background image

Installation and

Operation

This section describes the installation and the operation of the RGB 580xi. Topics that are
covered include:

•

Installation Overview

•

Application Diagrams

•

Front Panel Features and Cabling

•

Rear Panel Features and Cabling

•

Front Panel Adjustments

•

AAP Device Features

•

Cabling the AAP Device Rear Connectors

•

Cable Cubby AAP Device Features

•

Cabling the Cable Cubby AAP Devices

•

Troubleshooting

Installation Overview

CAUTION: Installation and service must be performed by authorized personnel only.

To install and set up an RGB 580xi, follow these steps:

1.

Turn all of the equipment off. Make sure that the computer, the RGB 580xi, and the
output devices (projector/monitor, speakers) are all turned off and disconnected from
the power source.

2.

For under-desk mounting:

a.

Determine the installation location: table, desk, podium, or other suitable location.
If Architectural Adapter Plates are to be connected to the interface, consider where
they will be located in relation to the interface. See

“Application Diagrams”

.

b.

Mount the interface. See

“Under-furniture Mounting”

.

3.

Attach output cables to the rear panel of the interface and to the output devices. See

“Rear Panel Features and Cabling”

.

4.

Attach input cables to the input devices and to the front panel connectors of the
interface. See

“Front Panel Features and Cabling”

.

5.

Set the front panel DIP switches. Use the

“Front Panel Features and Cabling”

section

as a guide.

6.

Connect power cords and turn on the output devices (projector/monitor, speakers).
Next, power up the remote interface, and then the audio and video input devices.

RGB 580xi • Installation and Operation

3

Advertising