Extron Electronics TLP 710TV User Guide User Manual

Page 17

Advertising
background image

k

Power connector — Connect the 2-pole, 3.5 mm captive screw connector from the
12 VDC, 1.0 A power supply (not provided) to the power supply socket on the rear
panel. Ensure the connections have the correct polarity as shown in figure 10.

NOTES:

•

Extron recommends using the Power over Ethernet power supply.
The 12 VDC, 1.0 A power supply should only be used for setup or
troubleshooting.

•

If both power supplies are connected to the TLP 710TV, the PoE power
supply takes precedence.

Power Receptacle

Captive Screw Connector

AC Power Cord

Ground
+12 VDC

External

Power Supply

(12 VDC, 1 A )

SECTION A–A

Ridges

Smooth

Power Supply

Output Cord

A

A

3/16"

(5 mm) Max.

Figure 10.

Power Supply Connection

ATTENTION: See the

Attention

on page 7 for important information about

power supplies.

NOTE: See the

notes

on page 7 for important information about wiring captive

screw connectors.

l

MTP signal adjustments — Three MTP signal adjustments are available for S-video
luminance gain (VID/Y), S-video chrominance gain (C), and sharpness (S). For
composite video signals, the gain is controlled by the VID/Y adjustment. Insert a small
Phillips head screwdriver into the recess and turn clockwise to increase adjustment or
counterclockwise to decrease.

m

VESA mounting holes — Four holes are arranged in a pattern that is in accordance
with the VESA FDMI standard, type D 75 mm (see

Figure 9

). See page 46 for more

information about

mounting the TLP 710TV with the Extron LPVM-1

.

TLP 710MV and TLP 710TV • Panel Features

11

Advertising
This manual is related to the following products: