Beko GNE V222 S - Manual (Page 24)

EN
23
• Use clean and pure drinking water only.
• Capacity of the water reservoir is 2.2
liters (3.8 pints); do not overfill.
• Push the arm of the water dispenser
with a rigid glass. If you are using
disposable plastic glasses, push the
arm with your fingers from behind the
glass.
• Safety lock is intended to provide
ease of usage when filling the water
reservoir and at the same time to
prevent little children to tamper with
the water dispenser.
Cleaning the water reservoir
Take out the water reservoir, release
the latches on both sides and detach
the upper cover mechanism from the
water reservoir. After cleaning the
water reservoir with warm clean water,
replace the upper cover mechanism
and lock the latches.
When mounting the water reservoir,
make sure that the hooks behind it
are securely attached to the hangers
on the door. Make sure that the parts
removed (if any) during cleaning are
properly attached to their original
places. Otherwise, water leakage may
occur.
Important:
Components of the water reservoir
and water dispenser should not be
washed in dishwasher.
Water tray
Water that dripped while using the
water dispenser accumulates in the
spillage tray. Take out the spillage
tray by pulling it towards yourself and
empty it regularly.
Take out the plastic strainer by
pressing it on sides as shown in the
figure.
Take the water valve out of the water
reservoir as shown in the figure. When
replacing it, make sure that the O-ring
seal is properly placed.
WARNING: Connect only to a drinking
water line.