Installation, Overview, Overview -2 – Extron Electronics TP T Series Transmitters User Guide User Manual

Page 12: Preliminar y, Installation and operation

Advertising
background image

TP T Series Transmitters • Installation and Operation

2-2

Installation and Operation

PRELIMINAR

Y

Installation

C

Installation and service must be performed by authorized personnel only.

Overview

To install and set up a TP transmitter for operation, follow these steps:

1

Disconnect power from all of the equipment, including the video source(s)

(such as computers or DVD players), the transmitter, the receiver(s), and the

output display(s).

2

If using component, S-video, or composite video, reconfigure the video

jumpers as needed. See “

Configuring video jumpers for component video,

S-video, and composite video

”, on the next page.

3

(TP T 15HD AV only) If desired, configure the audio jumpers to make the

transmitter compatible with unmodified TP receivers. See “

Setting audio

jumpers for use with unmodified receivers

”, later in this chapter.

N

The TP T 15HD AV is a redesigned (modified) transmitter. The audio jumpers

configure the audio portion of the composite video TP link to work with the
similarly redesigned TP R BNC AV receiver or with older, unmodified receivers.
Redesigned transmitters and receivers have an identifying label.

4

Mount the transmitter in a rack, under a desk or podium, or through a desk or

table as desired. See “

Mounting the transmitters

”, later in this chapter.

5

Connect the input cables. See “

Connectors and Cabling on the Front and Rear

Panels

”, later in this chapter.

6

Connect the output cable(s) from the transmitter to the TP receiver(s). See

“

Connectors and Cabling on the Front and Rear Panels

”, later in this chapter,

and refer to the TP Receivers Family User’s Manual for more information.

7

Configure the TP receiver(s). Refer to the TP Receivers Family User’s Manual.

8

Plug the included external 15 VDC power supply into the transmitter’s

three-pole captive screw connector, and power on the video source(s) and the

output display(s).

N

The transmitters can also receive power from the associated Extron TP

receiver(s) (except from the TP R 15HD A) via the TP cable. Extron
recommends using the local power supply; however, this may not be necessary
for some applications.

• The transmitters may not require a local power supply for cable lengths

of 300’ (91 m) or less.

• Any transmitter connected to a TP R 15HD A receiver always requires

the local power supply.

If you encounter problems, use the local power supply.

9

TP T 15HD A and TP T 15HD AV: Set the ID Pin 4 and ID Pin 11 DIP switches

on the front panel and the DDSP

™

DIP switch on the back panel as desired.

(See the

DIP switch descriptions

under “Connectors and Cabling on the Front

and Rear Panels”, later in this chapter.)

10

TP T 15HD A and TP T 15HD AV: Adjust the horizontal shift control on the

front panel of the transmitter and receiver(s). See “

Controls and Indicators on

the Front and Rear Panels

”, later in this chapter, and refer to the TP Receivers

Family User’s Manual

.

Advertising