Extron Electronics TPX 88 A User Guide - Manual (Page 74)

Matrix Software, cont’d
TPX 88 Matrix Switchers • Matrix Software 5-8
Button-Label Generator
The program is contained on the same set of 3.5-inch diskettes as the Matrix
Switcher+ Control Program and is installed automatically when you install that
program.
By default, the Windows installation goes in either the C:\MTRX50 directory if it is
installed automatically with the Matrix Switcher+ Control Program or the
C:\BUTTONS directory if it is installed as a stand-alone program. The Button-
Label Generator icon is placed in the “Extron Electronics” group or folder.
Using the software
1. To run the Button-Label Generator program, double-click on
the Button-Label Generator icon (shown at right) in the Extron
Electronics group or folder, and click OK when prompted. The
Extron’s Button-Label Generator window appears (figure 5-5).
Figure 5-5 — Extron’s Button-Label Generator window
2. Under System selection, choose SGS 408 (this selection matches the button
size of the TPX 88).
3. Using normal Windows controls, you can create and print labels that can be
placed in the label windows on the front panel of the switcher.
For information about using the program, you can access the help program by
clicking on the Help menu on the main screen and choosing Show Help.
You can also see an example of a completed Extron’s Button-Label Generator
window by clicking on the Help menu on the main screen, choosing Show Help,
and clicking on the Load Demo button.