Extron Electronics SW RGBHV Series User Guide - Manual (Page 15)

Installation, cont’d
SW RGBHV Series Switchers • Installation 2-4
SW4 and SW6 models
1 . If rubber feet were installed on the bottom of the switcher, remove them.
2 . Attach the rack mount brackets to the switcher with eight provided #8
machine screws, provided (figure 2-2).
#8 Screw (4 Plcs)
Each Side
Mounting Screws (2 Plcs)
Each Side
Rack-mount
Bracket
Under
Furniture-mount
Bracket
Drill pilot holes
3/32” (2.4mm) dia.
1/4” (6.3 mm) deep.
100-240V 1.3A
50-60Hz
REMO TE
AU TO
MANU AL
V
OUTPUT
R
G
B
H/
HV
INPUT 1
INPUT 2 R
G
B
H/HV
V
INPUT 3
INPUT 4 R
G
B
H/HV
V
INPUT 5
INPUT 6 R
G
B
H/HV
V
OUTPUT L R
INPUTS L R
L R 3
4
L R
L R 5
6
2
1 L R L R
or
Figure 2-2 — Mounting an SW4 or SW6 switcher in a rack or under
furniture
3 . Insert the switcher into the rack, aligning the holes in the mounting bracket
with those of the rack.
4 . Secure the switcher to the rack using the supplied machine screws.
Under-furniture mounting the switcher
The SW2 switcher models can be mounted under a table or other horizontal surface
with an optional Extron under-desk mounting kit (part #70-077-01). The SW4 and
SW6 switcher models can be mounted under a table or other horizontal surface
with an optional Extron 1U under-desk mounting kit (part #70-222-01).
SW2 models
1 . Secure the optional under-desk mounting brackets to the switcher with the six
machine screws provided in the mounting kit (figure 2-3).
2 . Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the mounting
surface.
3 . Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
4 . Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
5 . Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
6 . Slide the switcher slightly forward or back, then tighten all four screws to
fasten it in place.