Extron Electronics SW RGBHV Series User Guide - Manual (Page 4)

QS-1 SW RGBHV Series Switchers • Quick Start
Quick Start — SW RGBHV Switchers
Installation
Step 1 — Remove power
Turn off power to the input and output devices,
and remove the power cords from them.
Step 2 — Mounting
SW2 —
If desired, mount the switcher in a rack using an
Extron 1U Universal Rack Shelf, part # 60-190-01 or
60-604-02
.
If desired, mount the switcher under a desk using
an Extron Under-desk Mount Kit, part #70-077-01.
If desired, mount the switcher through a desk using
an Extron Through-desk Mount Kit, part #70-077-02.
SW4 or SW6 —
If desired, mount the switcher in a rack with the
supplied rack ears.
If desired, mount the switcher under a desk using
an Extron 1U Under-desk Mount Kit,
part #70-222-01.
Step 3 — Video Inputs
Connect up to 2, 4 or 6 RGBHV, RGBS, RGsB, or
RsGsBs video or component video inputs to the
Input connectors (3).
Step 4 — Video Output
Connect an RGBHV, RGBS, RGsB, or RsGsBs video
or component video display or other device to the
Output connectors (3).
G
RGBHV
RGBS
RGsB,
RsGsBs,
Component
B H /HV V
R G B H/ HV V
R G B H/HV V
3
Unbalanced Input
Tip
Sleeve
Tip
Sleeve
Balanced Input
Tip
Ring
Sleeve (s)
Tip
Ring
(high impedance) (high impedance)
5
Step 5 — Audio Inputs
Cable audio models for stereo audio input (5).
High impedance is generally over 10k ohms.
Step 6 — Audio Outputs
Cable audio models for stereo audio output (6).
Step 7 — Remote Control
Connect a host device, such as a computer or touch
panel control via RS-232, OR connect a remote
contact closure device to the switcher via this
9-pin D connector (7) for remote control of the
switcher.
To command a switch under contact closure
control, momentarily short an input’s pin on the
remote connector to ground (the switcher must be
in normal [manual] mode).
See chapter 4, “Remote Control”, for definitions of
the SIS commands and details on how to install and
use the control software.
Step 8 — Connect power
Plug the switcher, input devices, and output
devices into a grounded AC source, and turn on the
input and output devices.
Unbalanced Output
Tip
See caution
Sleeve
Tip
See caution
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
6
CAUTION
Connect the sleeve
to ground.
Connecting the
sleeve to a negative
(-) terminal will
damage the audio
output circuits.
Pin RS-232 Contact
closure
Function
1 — In #1 Input #1
2 TX
—
— Transmit data (-)
3 RX Receive data (+)
4 — In #2 Input #2
5 Gnd Gnd Signal ground
6 — In #3
In #4
In #5
In #6 Input #3
Input #6
Input #4
Input #5 7 —
8 —
9 —
Female
5 1
9 6
Male
1 5
6 9
7