Extron Electronics VSW 2VGA A User Guide - Manual (Page 21)

VSW 2VGA A • Installation and Operation 2-11
2 . Remove the two screws on each side of the switcher
(figure 2-9). Remove the four connector nuts on the front
panel of the switcher. Lift the top cover off of the switcher.
VSW 2VGA A
INPUT 1
2
1
INPUT 2
Remove (4)
Connector Nuts
Remove (4)
Screws
Figure 2-9 — Removing the cover
JMP4
JMP3
JMP5 JMP6
FRONT PANEL
JMP1
EXTR
ON 20-881-
nn
x
ER:-
yyyyyyyy yyyy
Figure 2-10 — VSW 2VGA A jumper locations
3 . Set the jumpers for the switcher. See figure 2-11.
4 . Set the cover in place and resinstall the screws remove in
step 2.
There are five jumpers, numbered JMP1, and JMP3 thru JMP6,
that control daisy chaining on the VSW 2VGA A switcher (figure
2-10). Both data and power must be daisy chained from one
switcher to another.