Extron Electronics VSW 2VGA A User Guide - Manual (Page 26)

VSW 2VGA A • Installation and Operation
Installation and Operation, cont’d
2-16
• Configure the jumpers on each VSW 2VGA A according to
the following example.
• The VSW I AAP is configured for a loop configuration by
default.
N In a loop configuration, the "show me" feature can be used
without a VSW I AAP control panel. Select Input 1 using
either the front panel toggle switch (see item c in "Front
Panel Features" ) or the rear panel contact closure control
(see item e in "Rear Panel Features") to issue the "show
me" control signal.
Loop configuration example
The illustration on the following page is an example of daisy
chaining using a loop configuration.