Extron Electronics System 5cr Plus - Manual (Page 27)

3-7 System 5cccccrrrrr Plus • Setup and Operation
Remote Control of the System 5cccccrrrrr Plus
The System 5 can be controlled by using its front panel controls, the included
IR 401 infrared remote control, optional SCP remote control panels, or an
RS-232 control device or computer.
The IR 401 and SCP control panels replicate the System 5’s front panel controls for
normal mode operations. The RS-232 control device also can send front panel
normal mode commands. A computer using Extron’s Windows-based control
program can perform both normal mode and setup mode operations, and it offers
some functions that are not available with the other control methods. See chapter 4,
Serial Communication, for details.
The IR 401 uses and buttons in
place of the volume knob. It also has
an audio mute button.
Setup mode operations can not be
performed from the IR 401.
Control Functions Audio
Input Selection
Display
Power
Display
Mute
Mode
Room
Mute
Volume
4 3 2 1
5
System 5cr Plus Remote
Control Functions Audio
Input Selection
Display Power Display Mute
Mode
Room
Mute
Volume
4 3 2 1
5
IR 401
To interpret the System 5’s response to the IR learning steps, see the LED response
codes below.
Key to LED Codes
Command
has been
learned
Continue
with setup
or exit to
normal
mode.
Ready to learn
the power-off
command
Timeout exit to
normal mode
will occur
Press any
button to stay in
setup mode.
Try again
Setup
mode is
active
Configure
a
System 5
feature.
Off
On
Off
Blinks once
On
Blinks once
Off
On
Blinks once
Blinks for 5 seconds
Blinks for 5 seconds
Blinks for 5 seconds
Off
On
Blinking
Off
Blinking
Blinking
Off
Blinking
Off
Ready to
learn IR
commands
Aim projector's
remote at IR
learning port.
Press a button
for the
function on
the remote.
No IR
subcarrier
was received
Double-click the
System 5's
Display Power
button, then press
the power button
on the projector's
remote.
Press the
same System 5
Display button
again,
and press the
IR remote's
button again.
Press the
same button
again on the
projector's
IR remote.
Status
What
to do
next
TX
CONFIG
RETRY
The SCP 100P, SCP/AAP A, and SCP 250 can be mounted in a wall or furniture.
Each includes an IR remote window (corresponding to the IR receiver port on the
System 5) or IR signal pickup device for receiving
commands from the IR 401 remote control and sending
them to the System 5. Infrared signals from other
devices are not passed on to the IR Emitter or the IR
Broadcaster. Up to two SCPs can be connected to the
System 5.
SHOW ME
MAX/
MIN
AUDIO
VOLUME
POWER MUTE
DISPLAY
MODE
SCP / AAP A