Arcam FMJ A38 - Manual (Page 16)

e-16
a38 P38
Continuous power output (20Hz—20kHz at 0.5% THD), per channel
Both channels, 8
Ω , 20Hz—20kHz 100W 100W
Single channel, 8 Ω , 20Hz—20kHz 150W 150W
Both channels, 4 Ω , 20Hz—20kHz 140W 140W
Single channel, 4 Ω , at 1kHz 200W 200W
Harmonic distortion, 80% power, 8 Ω at 1kHz 0.005% 0.005%
Inputs
Phono input (optional module):
Input sensitivity
2.7mV (MM); 270µV (MC)
Input impedance 47k Ω (MM); 300 Ω (MC)
Signal/noise ratio (CCIR) –79dB (MM); –73dB (MC)
Overload margin 35dB
Line inputs:
Nominal sensitivity
250mV—2V 800mV (pre-amp. in)
Input impedance 10k Ω 10k Ω
THD+n (1kHz, 0dB signal, measured 20Hz to
20kHz unweighted)
–104dB –104dB
Power amplifier input
Nominal sensitivity
800mV 800mV
Input impedance 22k Ω 22k Ω
Gain 31.5dB 31.5dB
Preamplifier output
Nominal output level
700mV
Maximum output level 2.6V RMS
Output impedance <50 Ω
Headphone output
Maximum output level into 600
Ω 1.6V rms
Output impedance 4.7 Ω
General
Mains voltage
115V or 230V 115V or 230V
Power consumption (maximum) 800VA 800VA
Power consumption (standby) 2VA 2VA
Dimensions W x D x H (including feet) 430 x 370 x 110mm 430 x 350 x 110mm
Weight (net) 9.3kg 9.5kg
Weight (packed) 12.2kg 12.5kg
Supplied accessories mains lead
CR90 remote control
4 x AAA batteries
mains lead
E&OE
NOTE: All specification values are typical unless otherwise stated.
continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.
specifications