Imetec NUVOLA - Manual (Page 15)

EN
13
PREPARATION
Sort the laundry according to the international symbols shown on the label; if this is missing,
sort according to the type of material.
Start to iron the garments that require a lower temperature so as to reduce idle time (the iron
requires less time to warm up than to cool down) and eliminate the risk of burning the fabric.
synthetic, acrylic, nylon, polyester: low temperatures;
wool, silk: medium temperatures;
cotton, linen: high temperatures;
do not iron.
USE
FIRST USE
Bring the handle to a vertical position until it clicks [Fig. A]. When used for the first time, you
may notice some smoke or noise due to the expansion of the plastic material. This is normal
and will stop after a short while.
Warning: pass the iron on a cloth to eliminate any impurity in the steam
device.
FILLING THE RESERVOIR
• Make sure that the plug is disconnected from the socket.
• Open the reservoir cover located on the handle (2).
• Fill the reservoir [Fig. B] with tap water and close the cover (2).
SELECTING THE TEMPERATURE
• Place the iron in a vertical position and insert the plug into the socket.
• Set the temperature selector (6) [Fig. C] according to the international symbols on the
garment labels. Wait a few minutes before you start ironing.
Warning: if you set the selector to a lower temperature after having
ironed at high temperature, wait a few minutes to give the plate the time
to reduce the temperature.
DRY IRONING
Dry iron by not pressing the steam button (1).
Attention! For delicate fabrics, we recommend dampening them or
placing a damp cloth between.