Imetec NUVOLA - Manual (Page 16)

EN
14
STEAM IRONING
• Press the super-steam button (1) [Fig. D] to dispense steam.
• Wait a few seconds before pressing it again.
AFTER IRONING
EMPTYING PROCESS
• Disconnect the plug from the socket.
• Release the reservoir cover (2).
• Empty the reservoir by turning the iron upside down and shaking it lightly.
• Let the iron cool down completely in an upright position.
MAINTENANCE
CLEANING
ATTENTION!
Make sure the plug of the appliance is disconnected from the socket
and the plate has cooled down completely before cleaning the iron.
Any starch deposits or residue on the surface of the plate can be removed with a damp cloth
and non-abrasive liquid detergent.
Avoid scratching the plate with steel wool or metal objects.
The plastic parts can be cleaned with a damp cloth and then wiped with a dry cloth.
TROUBLESHOOTING
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem Possible cause Solution
The plate (7)
remains cold or
does not heat up.
There is no power supply.
Verify whether the plug is inserted
correctly or try inserting it in another
socket.
Verify whether the temperature
selector (6) is set to the minimum
temperature Ø (Fig. C).
Only a little steam
or none at all is
dispensed.
There is not enough water
in the reservoir.
Fill the reservoir (see Chap. FILLING
THE RESERVOIR).