Imetec NO-STOP PROFESSIONAL ECO - Manual (Page 14)

EN
12
IMPORTANT GUIDELINES
The appliance is designed to work with tap water; however, if the
water in your area is very hard, mix the tap water (50%) with distilled
and/or demineralised water (50%). Salt concentration in water in
certain seaside areas is very high: in such cases it is important to use
“demineralised water for irons” available on the market. If in doubt,
only demineralised water for steam irons must be used.
Do not use diluting agents, scented liquids or descaling agents as
these substances can damage the product. Do not use water from
dryers, air-conditioners and rain water.
The boiler may contain some water as each product is tested before
being put on the market.
It is recommended to place a cloth between the iron and the fabric
when using the iron for the first time.
It is recommended to direct a jet of steam into the air before starting
to iron, for any residual condensation to be let out.
SYMBOLS
WARNING PROHIBITION
DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES
Refer to the illustrative guide at the beginning of this user manual to verify your appliance
equipment. All the figures are on the cover pages of these instructions for use
1. Reservoir water fill cover
2. Water reservoir
3. ECO button
4. Steam adjustment knob
5. Steam (ready) LED (green)
6. Boiler cleaning LED (yellow)
7. No water LED (blue)
8. Technical data
9. Iron mat
10. MAX fill-up level
11. Cleaning cap
12. ON/OFF button
13. Plug
14. Multi-hole plate
15. Steam button
16. Iron temperature adjustment knob
17. Plate temperature LED
18. Cable duct