Imetec BM2 200 - Manual (Page 6)

GB
• Close the battery compartment (7) and wait for the LCD display (1) to display the content
below.
SELECTInG THE unIT oF MEASurEMEnT
• Press the UNIT button (6) [Fig. 3] to select the unit of measurement (kg/lb and cm/ft). Each
time it is pressed, the LCD display changes the unit of measurement shown (1):
SELECTInG THE uSEr
• Press the USERS button (3) to activate the user selection mode.
• "P1" will start to flash on the LCD display (1).
• Press the USERS button (6) to switch to the next users - “P2”, “P3”, “P4”, “P5” - until your
reference number is displayed.
• The screen will display your user code for 2 seconds and then the scales is set to 0.0Kg.
• If you wish to change user, repeat the procedure as illustrated above.
4
lb
ft