Imetec SENSUIJ SM5-200 - Manual (Page 48)

43
EN
DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig.A)
1-6. securing straps
2. Rotating massaging heads
3. Connectors
4. Mains power supply with connectors
5. Control
ASSEMBLY/PREPARATION
• Unpack the product and remove the stops used for transport.
• Check that it is integral and undamaged.
Upon commissioning, release the transport safety device of the massaging
mechanism. Loosen the screw on the rear of the chair back using the appropriate
tool.
ATTENTION!
The massager pillow will be irreparably damaged and it will no longer be usable unless
the transport safety screw is removed before using the product. This case is not covered
by warranty. Once removed, the screw must no longer be re-inserted.
The massager pillow is supplied with Velcro securing straps making it possible to adapt it to the
majority of chairs available on the market. Pass the two straps (1) (6) behind the chair back and
secure them to each other using the Velcro. If you prefer, simply rest the massager pillow on your chair
or armchair. Do not use it on wooden surfaces as it may be damaged.
ATTENTION!
The massager pillow is unsuitable for use in a car.
• Connect the transformer to the massager pillow via the specific connectors (3) (4).
• Connect the product to the domestic mains.
USE
• Press the ON/OFF (5) key to switch-on the massager pillow.
• Press the ON/OFF
(5)
key again to stop.
HEAT: heating function.
• Press the HEAT
(5)
button to activate heat during the massage. The HEAT function activates only if the
massage is functioning.
• Press it again to deactivate it.
• Use a towel if wanting a more delicate massage.
AUTOMATIC SHUTDOWN
The massager pillow turns itself off automatically after 15 minutes. This function does not replace the
normal turning off of the product, which must be off when not in use.
When the product is switched off, the massage mechanism always returns to starting position. When
switched on again, the massage will start from this position.