IPX DDK-1800 - Manual (Page 31)

“Flip”, “White Balance”, “Brightness”, “Contrast”, “Saturation” and “Sharpness”.
4. DEVICE SETTINGS. Includes “Device Name” and “Timestamp”.
• Click “Enable OSD” and checkmark the box to activate this function.
• Enter "Timestamp Label".
• Enter "Timestamp Location".
5. Click the Submit button to submit new image settings
Functions:
Metering Method
The metering method determines the exposure. Different metering
methods measure the subject brightness differently.
Center-weighted:
The metering is weighted at the center and then
averaged for the entire scene.
Spot:
This is for metering the central part of the entire scene.
Exposure Mode
Exposure Mode controls a camera by shutter speed and the lens aperture.
Indoor:
The optimum exposure setting is pre-programmed for the indoor
environment. The default shutter time is 1/30~1/120 (1/25~1/100)
and the maximum gain is 36 dB.
Outdoor:
The optimum exposure setting is pre-programmed for the
outdoor environment. The default shutter time is 1/30~1/750
(1/25~1/750) and the maximum gain is 36 dB.
Night: The optimum exposure setting is pre-programmed for the night
environment. The default shutter time is 1/30~1/750 (1/25~1/500)
and the maximum gain is 12 dB.
Moving: The optimum exposure setting is pre-programmed for moving
subjects. The default shutter time is 1/120~1/1,000
(1/100~1/1,000) and the maximum gain is 36 dB.
Low noise:
The optimum exposure setting is pre-programmed to reduce
the noise. The default shutter time is 1/8~1/30 (1/7.5~1/25) and
the maximum gain is 36 dB.
Customize 1-3: You can customize an exposure mode by adjusting
individual parameters like Gain and Shutter.
Schedule: In the Schedule mode, you can set the customize schedule.
Select a schedule and set the time period. You can assign one
of the exposure modes to be the function mode of the
Remaining time. Check and press to Save.
Note: The period of the schedule can’t be set across midnight. For
example, if you want to set a schedule of Night mode from
22:00 to 04:00, you have to (1) check a schedule and select the
Night mode and set the period from 22:00 to 24:00, then (2)
enable the next schedule and set it to Night mode and set the
period from 00:00 to 04:00. Remember to click Save to activate.
Denoise Denoise
(noise reduction) is the process of removing noise from signals.
31