IPX VE-3500 - Manual (Page 55)

Change the Application Setting — Alarm - Motion Detection.
Please follow the steps below to enable changes in the motion detection function of the alarm
through the network if necessary.
Set the motion detection:
1. Click
the Motion Detection button on the left side of the Alarm to enter the “Motion Detection”
page.
2. Click and drag the left mouse button to across a targeted zone to draw a red rectangle on the
image (coordinates provided below).
NOTE:
You can set more than one targeted zone depending on your requirement.
3. Click the right mouse button to see the popup-menu. After setting the target zone, please click
“Save setting”.
4. Enables / disables the motion detection function.
5. Set up the sensitivity.
6. Click the
Submit
button to submit the new setting of the recording.
7. Click the
Home
button to return to the home page.
Note:
Press and hold the “Ctrl” key on your keyboard and use the left mouse key to draw a blue
rectangle on the image to disable the motion detection area.
You also can click the left mouse key directly on a red check to disable it.
53